| JoeCustoms.com https://www.docs.joecustoms.com/forums/ |
|
| Need help identifying a part I used in a custom https://www.docs.joecustoms.com/forums/viewtopic.php?f=15&t=47403 |
Page 1 of 1 |
| Author: | MJTanner [ Wed Sep 18, 2019 6:42 pm ] | ||
| Post subject: | Need help identifying a part I used in a custom | ||
So on the Fallout power armor custom on the right..I used this chest piece (circled). I modded it quite a bit but I think if you've seen the original you can recognize it.. my problem is I need two more, but I can't remember where I got it. I THINK it's a Corps accessory--maybe a pack in with some vehicles? Anybody have it or recognize it?
|
|||
| Author: | mukami [ Wed Sep 18, 2019 9:29 pm ] |
| Post subject: | Re: Need help identifying a part I used in a custom |
It looks like one of these: Marvel Universe Iron Man 2 ... well at least the waist and upper legs do. |
|
| Author: | pluv [ Thu Sep 19, 2019 10:58 am ] |
| Post subject: | Re: Need help identifying a part I used in a custom |
mukami wrote: I had a similar thought, Marvel Titanium Man or Ultron, but while similar it doesn't quite match. |
|
| Author: | MJTanner [ Thu Sep 19, 2019 12:44 pm ] |
| Post subject: | Re: Need help identifying a part I used in a custom |
Sorry I wasn't clear-- it's chest piece-- not part of the base figure. This was something that would snap on to the torso. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|