JoeCustoms.com
https://www.docs.joecustoms.com/forums/

Anyone interested in part casting tutorials?
https://www.docs.joecustoms.com/forums/viewtopic.php?f=15&t=44483		 Page 1 of 1
Author:  LobsterOverlord [ Wed Apr 13, 2016 9:24 pm ]
Post subject:  Anyone interested in part casting tutorials?
Hi all,

This weekend is a 3-day for me and I am going to do some molds. Any one have any interest in me doing pics and step by steps?

I am going to do some 1 and some 2-part molds.

These are very basic hobby level molds, as I don't have some higher end equipment (de-gassing chamber, etc.)

John M>
Author:  Rescuer [ Wed Apr 13, 2016 11:36 pm ]
Post subject:  Re: Anyone interested in part casting tutorials?
Sure, I 5hink any tutorials would be helpful, especially with step-by-step pics!
Author:  pluv [ Thu Apr 14, 2016 9:29 am ]
Post subject:  Re: Anyone interested in part casting tutorials?
All tutorials are always welcome. We have some on casting, but not everyone does anything the same, so it is always good to show the different techniques.
Author:  Mainframe [ Thu Apr 14, 2016 9:04 pm ]
Post subject:  Re: Anyone interested in part casting tutorials?
LobsterOverlord wrote:
Hi all,

This weekend is a 3-day for me and I am going to do some molds. Any one have any interest in me doing pics and step by steps?

I am going to do some 1 and some 2-part molds.

These are very basic hobby level molds, as I don't have some higher end equipment (de-gassing chamber, etc.)

John M>


oh yes, please. :like:
Author:  forcefull1 [ Wed May 11, 2016 8:09 am ]
Post subject:  Re: Anyone interested in part casting tutorials?
You big tease! Still thinking about doing these tutorials?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/